open_pre_freewave_streams() returns ok
program_init(): A Belated hello after open_pre_freewave_streams()
setup_sensor_array(): entered
setup_sensor_array(): sensors set up ok
init_sensors()
parse_surface_display_configfile() : Attempting to open CONFIG.SRF
    The following sensors will be displayed during surface intervals:
    m_final_water_vx(m/s)
    m_final_water_vy(m/s)
    m_water_vx(m/s)
    m_water_vy(m/s)
    c_wpt_lat(lat)
    c_wpt_lon(lon)
    x_last_wpt_lat(lat)
    x_last_wpt_lon(lon)
    m_battery(volts)
    m_leakdetect_voltage(volts)
    m_leakdetect_voltage_forward(volts)
    m_vacuum(inHg)
    m_tot_num_inflections(nodim)
    u_use_current_correction(nodim)
    m_iridium_signal_strength(nodim)
    m_coulomb_amphr(amp-hrs)
    m_coulomb_amphr_total(amp-hrs)
    m_avg_climb_rate(m/s)
    m_avg_dive_rate(m/s)
init_picozoom(): persistor is 512 KB
init_picozoom(): There is enuf ram to enable picozoom
init_picozoom(): PicoZoom successfully enabled
program_init():init_simulator()
init_simulator()
init_simulator() returning without error
program_init():glider_init()
Init_Qbus()
dump_and_close_pre_freewave_streams()